V3800-Cr-Te4, V3800-Cr-Tie4, V3800-Cr-Te4C, V3800-Cr-Tie4C - Kubota D1803-CR-E4 Workshop Manual

DIESEL PARTICULATE FILTER HANDLING MANUAL, WSM

(4) V3800-CR-TE4, V3800-CR-TIE4, V3800-CR-TE4C, V3800-CR-TIE4C

Connector of Exhaust Temperature Sensor
1. Disconnect the connectors of exhaust temperature sensor (2),
(3), (4) and differential pressure sensor (1) from wiring harness.
2. Remove the connectors of exhaust temperature sensor (2), (3),
(4) from the bracket.
3. Remove the clamps (5).
4. Unscrew the stay mounting bolt (7), and remove the DPF stay 1
(6).
(1) Differential Pressure Sensor
(2) Connector of Exhaust Temperature
Sensor T2
(3) Connector of Exhaust Temperature
Sensor T1
Separation of Muffler Full Assembly (DPF)
1. Set chain sling by using shackle at two places (a) and (b) as
shown in the photograph.
2. Unscrew the screws of muffler flange (1).
3. Unscrew the muffler full assembly (DPF) mounting screws (2).
4. Lift up the muffler full assembly (DPF) safely, and separate it
from the engine.
NOTE
• When lifting the muffler full assembly (DPF), use caution so
that the pressure pipe 1 (3) does not hit the EGR pipe (4).
(1) Screw of Muffler Flange
(2) Muffler Full Assembly (DPF)
Mounting Screw
(3) Pressure Pipe 1
(4) EGR Pipe
1-S11
ENGINE
(4) Connector of Exhaust Temperature
Sensor T0
(5) Clamp
(6) DPF Stay 1
(7) Stay Mounting Bolt
(a) Shackle Set Position
(b) Shackle Set Position
KiSC issued 09, 2013 A