V3800-Cr-Te4, V3800-Cr-Tie4, V3800-Cr-Te4C, V3800-Cr-Tie4C - Kubota D1803-CR-E4 Workshop Manual

DIESEL PARTICULATE FILTER HANDLING MANUAL, WSM

(4) V3800-CR-TE4, V3800-CR-TIE4, V3800-CR-TE4C, V3800-CR-TIE4C

Mounting of Muffler Full Assembly (DPF)
1. Set the chain sling by using shackle at two places (a) and (b) as
shown in the photograph.
2. Lift the muffler full assembly (DPF) (1), and guide it to the
installation position.
3. Assemble the muffler full assembly (DPF) (1) with the muffler
full assembly (DPF) mounting screw (5) and the screw of muffler
flange (4).
4. Remove the chain sling.
NOTE
• When guiding the muffler full assembly (DPF) to the
installation position, use caution so that the differential
pressure pipe (3) does not hit the EGR pipe (2).
Muffler full assembly (DPF)
mounting screw
Tightening torque
Screw of muffler flange
(1) Muffler Full Assembly (DPF)
(2) EGR Pipe
(3) Differential Pressure Pipe
(4) Screw of Muffler Flange
(5) Muffler Full Assembly (DPF)
Mounting Screw
Connector of Exhaust Temperature Sensor and DPF Stay 1
1. Install the DPF stay 1 (5).
2. Connect the connectors of exhaust temperature sensor (1), (2),
(3), and fix wiring with clamps (4).
Tightening torque DPF stay mounting bolt
(1) Connector of Exhaust Temperature
Sensor (T2)
(2) Connector of Exhaust Temperature
Sensor (T1)
1-S33
ENGINE
49.0 to 55.9 N·m
5.00 to 5.70 kgf·m
36.2 to 41.2 lbf·ft
49.0 to 55.9 N·m
5.00 to 5.70 kgf·m
36.2 to 41.2 lbf·ft
(a) Shackle Set Position
(b) Shackle Set Position
49.0 to 55.9 N·m
5.00 to 5.70 kgf·m
36.2 to 41.2 lbf·ft
(3) Connector of Exhaust Temperature
Sensor (T0)
(4) Clamp
(5) DPF Stay 1
KiSC issued 09, 2013 A