Kubota D1803-CR-E4 Workshop Manual page 30

DIESEL PARTICULATE FILTER HANDLING MANUAL, WSM
Judgment of Reuse by Cleaning Contractor
1. After having cleaned the DPF filter complete, measure the
actual cell depth (E) with a pin gauge in the each block shown
in the figure. One cell (The measurement point is not specified)
is measured in each block.
Model
D1803-CR-E4
D1803-CR-TE4
V2403-CR-E4
V2403-CR-TE4
V2607-CR-E4
V2607-CR-TE4
V3307-CR-TE4
V3800-CR-TE4
V3800-CR-TIE4
V3800-CR-TE4C
V3800-CR-TIE4C
(1) Pin Gauge (0.60 to 0.80 mm dia.,
0.024 to 0.031 in. dia.)
(2) DPF Filter Complete
(a) Serial No.
1-S20
ENGINE
Measurement total
16 blocks
16 blocks
25 blocks
28 blocks
(A) Exhaust Inlet Side
(B) Exhaust Outlet Side
(C) Accumulated Ash
(D) 150 mm (5.91 in.)
(E) Actual Cell Depth
(F) Accumulated Ash Depth
(G) Cell Depth
[A] D1803-CR-E4, D1803-CR-TE4,
V2403-CR-E4, V2403-CR-TE4
[B] V2607-CR-E4
[C] V2607-CR-TE4, V3307-CR-TE4
[D] V3800-CR-TE4, V3800-CR-TIE4,
V3800-CR-TE4C,
V3800-CR-TIE4C
(To be continued)
KiSC issued 09, 2013 A