DIESEL PARTICULATE FILTER HANDLING MANUAL, WSM
(3) V2607-CR-TE4, V3307-CR-TE4
Connector of Exhaust Temperature Sensor
1. Disconnect the connectors of exhaust temperature sensor (7),
(8), (9) and differential pressure sensor (11) from wiring
harness.
2. Remove the connectors of exhaust temperature sensor (7), (8),
(9) from the bracket.
3. Remove the clamps (6).
4. Remove the differential pressure sensor bracket (10).
(1) Exhaust Temperature Sensor (T2)
(2) Exhaust Temperature Sensor (T1)
(3) Exhaust Temperature Sensor (T0)
(4) Nut of Muffler Flange
(5) Muffler Flange
(6) Clamp
(7) Connector of Exhaust Temperature
Sensor (T0)
Separation of Muffler Full Assembly (DPF)
1. Unscrew the nut of muffler flange.
2. Unscrew the muffler full assembly (DPF) mounting screws (2).
3. Remove the muffler full assembly (DPF) (1).
NOTE
• When installing and removing the DPF muffler, make sure
that the temperature sensor, differential pressure sensor,
and differential pressure pipe do not make contact with
surrounding parts.
(1) Muffler Full Assembly (DPF)
1-S10
ENGINE
(8) Connector of Exhaust Temperature
Sensor (T1)
(9) Connector of Exhaust Temperature
Sensor (T2)
(10) Differential Pressure Sensor
Bracket
(11) Differential Pressure Sensor
(2) Muffler Full Assembly (DPF)
Mounting Screw
KiSC issued 09, 2013 A