User Interface Configuration; Enter User Interface View; Configure The User Interface-Supported Protocol - Huawei Quidway S5000 Series Operation Manual - Getting Started

Operation Manual - Getting Started
Quidway S5000 Series Ethernet Switches
Number of VTY: The first VTY interface is designated as VTY 0, the second one is
designated as VTY 1, and so on.

4.2 User Interface Configuration

User interface configuration includes:

Enter user interface view

Configure the user interface-supported protocol

Configure the Attributes of AUX (Console) Port
Configure the Terminal Attributes
Manage users
Configure redirection
4.2.1 Enter User Interface View
The following command is used for entering a user interface view. You can enter a
single user interface view or multi user interface view to configure one or more user
interfaces respectively.
Perform the following configuration in system view.
Table 4-1 Enter user interface view
Enter a single user interface view or multi user interface views
4.2.2 Configure the User Interface-supported Protocol
The following command is used for setting the supported protocol by the current user
interface. You can log in switch only through the supported protocol. The configuration
become effective when you log in again.
Perform the following configurations in user interface (VTY user interface only) view.
Table 4-2 Configure the user interface-supported protocol
Configure the user interface-supported protocol
By default, the user interface only supports Telnet protocol.
Operation
Operation
4-2
Chapter 4 User Interface Configuration
Command
user-interface [ type ] first-number
[ last-number ]
Command
protocol inbound { all | ssh | telnet }