Configure Redirection - Huawei Quidway S5000 Series Operation Manual - Getting Started

Operation Manual - Getting Started
Quidway S5000 Series Ethernet Switches
Note:
When a user logs in the switch, the command level that it can access depends on two points. One is the
command level that the user itself can access, the other is the set command level of this user interface. If
the two levels are different, the former will be taken. For example, the command level of VTY 0 user
interface is 1, however, you have the right to access commands of level 3; if you log in from VTY 0 user
interface, you can access commands of level 3 and lower.
IV. Set command priority
The following command is used for setting the priority of a specified command in a
certain view. The command levels include visit, monitoring, configuration, and
management, which are identified with 0 through 3 respectively. An administrator
assigns authorities as per user requirements.
Perform the following configuration in system view.
Table 4-17 Set command priority
Set the command priority in a specified view.
Restore the default command level in a specified view.
Note:
Please do not change the command level at will for it may cause inconvenience of maintenance and
operation.

4.2.6 Configure Redirection

I. send command
The following command can be used for sending messages between user interfaces.
Perform the following configuration in user view.
Table 4-18 Configure to send messages between different user interfaces.
Configure to send messages between different user interfaces.
Operation
Operation
4-9
Chapter 4 User Interface Configuration
Command
command-privilege level level view view command
Undo command-privilege view view command
Command
send { all | number | type number }