Huawei Quidway S5000 Series Operation Manual - Getting Started page 8

Operation Manual - Getting Started
Quidway S5000 Series Ethernet Switches
Workstation Workstation
Serv er Serv er
Figure 2-5 Set up configuration environment through telnet
Step 3: Run Telnet on the PC and input the IP address of the VLAN connected to the PC
port.
Figure 2-6 Run Telnet
Step 4: The terminal displays "User Access Verification" and prompts the user to input
the logon password. After you input the correct password, it displays the command line
prompt (such as <Quidway>). If the prompt "Too many users!" appears, it indicates that
too many users are connected to the Ethernet through the Telnet at this moment. In this
case, please reconnect later. At most 5 Telnet users are allowed to log on to the
Quidway series Ethernet Switches simultaneously.
Step 5: Use the corresponding commands to configure the Ethernet switch or to
monitor the running state. Enter "?" to get the immediate help. For details of specific
commands, refer to the following chapters.
Note:
1) When configuring the Ethernet switch via Telnet, do not modify the IP address of it unless necessary, for
the modification might cut the Telnet connection.
2) By default, when a Telnet user logs in, he can access the commands at Level 0.
Ethernet Ethernet
Workstation Workstation
PC ( for configuri n g the switch PC ( for configuri n g the switch
via Telnet ) via Telnet )
Chapter 2 Logging in Ethernet Switch
Ethernet port Ethernet port
2-4