Field Brake Max - Curtis 1268 Manual

3 — PROGRAMMABLE PARAMETERS
16
The parameter names are listed here in the abbreviated forms that appear on
the handheld programmer's 14-character LCD screen. Not all of these param-
eters are available on all controllers; the parameters for any given controller are
dependent on its specifications.
For a list of the parameters in the order in which they are displayed in
the Program menu, see Appendix B.
For an alphabetical list and index of the parameters, see Appendix C.
Acceleration Parameters
ACCEL (M1, M2, REV)
DECEL (M1, M2, REV)
FLD BRAKE
FLD BRAKE SPD
FLD BRAKE MAX
FLD BRAKE RATE
Speed Parameters
FWD SPEED (M1, M2)
REV SPEED
RPM TO SPEED
TACHO POLES
Throttle Parameters
THROTTLE 0%
THROTTLE 100%
THROTTLE MAP
THROT FAULT LO
THROT FAULT HI
Current Limit Parameters
MAIN C/L (M1, M2)
REGEN C/L
PLUG C/L
WALKAWAY C/L
Brake Mapping Parameters
BRAKE MIN (M1, M2, REV)
BRAKE MAX (M1, M2, REV)
BRAKE START (M1, M2, REV)
BRAKE END (M1, M2, REV)
BRAKE MAP (M1, M2, REV)
Field Mapping Parameters
FWD FLD MIN (M1, M2)
REV FIELD MIN
FIELD MAX
NEG FIELD MAX
FLD MAP START / NEG FLD MAP ST
FIELD MAP END / NEG FLD MAP EN
FIELD RAMP / NEG FLD RAMP
FIELD DIR SWAP
Fault Parameters
KSI SRO ENABLE
MODE AFTER KEY
OVERVOLTAGE
LOW VOLTAGE
WARNING OPTION
Output Driver Parameters
AUX DRVR MODE
AUX PULL IN
AUX HOLDING
EMB DELAY
EMB SPD CHECK
EMB SPD VALUE
DRV OVRCUR DIS
Curtis 1268 Manual,
Rev. D