Thrush Aircraft S2R–T660 Maintenance Manual page 85

THRUSH AIRCRAFT INC - T660 TURBO THRUSH
8. Np tach generator.
9. Prop beta micro switch.
10. Overspeed governor prop test solenoid (Be sure to install the two ground wires on
the mounting stud.)
11. ITT harness at the T5 terminal block.
D. Connect the engine controls.
1. Attach the propeller control cable housing to the forward fireseal and connect the
propeller control rod end to the propeller governor control lever.
2. Connect the fuel condition control cable rod end at the FCU condition lever.
3. Connect the power control cable rod end at the FCU power input lever.
E. Install the propeller.
F. Rig the engine controls.
G. If necessary, refer to the Engine Maintenance Manual for depreservation of the engine oil
and fuel systems.
H. Service the engine oil system.
I. Remove the cover from the compressor inlet screen.
J. Install the engine cowling.
K. Perform the engine ground test and checks. (Refer to procedures outlined later in this
section and Pratt & Whitney Maintenance Manual.)
Effective: 12/17/03
AIRCRAFT MAINTENANCE MANUAL
* NOTE *
Clean terminal ends and torque the ITT harness
connections in accordance
Maintenance Manual.
** CAUTION **
Prior to engine run-up, ensure the engine air inlet
plenums are free of foreign objects.
with the Engine
4 – 12