Thrush Aircraft S2R–T660 Maintenance Manual page 49

INTENTIONALLY LEFT BLANK
Inspect all cables and end fittings for wear. Check for correct
2.
tension.
Check all push rods for loose bearings, endplay, straightness
3 .
and paint condition.
4. Check idlers and bellcranks for binding or for slack.
Inspect the rudder pedals and the support brackets for
5 .
general condition.
Inspect the attachment of the control stick to the main torque
6.
tube for slack and bearing wear.
Check control stick to main torque tube bolt for proper torque
7 .
(65 to 70 in. lbs.)
Check the aileron control stops for tightness and for condition
8.
of fittings.
Inspect all push-pull tubes rod-end jam nuts for security.
Inspect all witness/inspection holes with a piece of .032"
9 .
safety wire to insure that all rod-ends are screwed far enough
onto the push-pull tubes.
10. Inspect the push rods for clearance to the structure.
Inspect the trim systems for correct operation and for general
11.
condition.
Remove control stick from main the torque tube bolt, inspect
12.
and replace bolt as required.
Effective: 12/17/03
THRUSH AIRCRAFT INC - T660 TURBO THRUSH
AIRCRAFT MAINTENANCE MANUAL
50 100
Daily
HRS HRS
X
X
X
X
X
X
X
X
X
X
X
2- 31
400
HRS