Thrush Aircraft S2R–T660 Maintenance Manual page 36

D. Wiring is to be checked for security, chafing, burning, defective insulation, and loose or broken
terminals, heat deterioration, and corroded terminals.
E. Bolts in critical areas are to be checked for correct torque, or when visual inspection indicates
the need for a torque check. See (Fig 2-7) Torque Chart..
F. Filters, screens, and fluids are to be checked for cleanliness, contamination and/or
replacement at specified intervals.
This Manual contains information on aircraft systems and operating procedures required for safe
and effective maintenance. It shall not be used as a substitute for sound judgment.
Clean the aircraft prior to performing any inspections on the airframe or engine. Before removal of
detachable skins, fairings, and cowlings wash all exterior surfaces of the aircraft with plain water
and any commercial soap or detergent. Soap and detergent are organic chemicals and it is
important that all traces be removed by flushing with plain water.
Inspection intervals are greatly influenced by particular operational priorities, operating conditions,
environment, and routine inspection results.
Perform the tasks shown in the following Inspection Chart at the prescribed intervals.
2 - 18
THRUSH AICRAFT INC - T660 TURBO THRUSH
AIRCRAFT MAINTENANCE MANUAL
*NOTE*
Certain chemicals cannot
effectively by detergent solutions. Special
cleaning agents are available for that purpose.
It is suggested that the chemical suppliers be
contacted for cleaning agents that are suitable
for those special needs.
be removed
Effective: 12/17/03