Thrush Aircraft S2R–T660 Maintenance Manual page 84

B. Connect the following tube and hose assemblies at the locations noted:
1. Oil cooler augmentation lines and hoses.
2. Gas generator case front drain valve hose.
3. Torque system lines at forward fireseal.
4. Gas generator case rear drain valve line.
5. Fuel inlet, outlet hoses, and vent line (three places) at the engine driven fuel boost
pump.
6. Oil cooler hoses (2) at the engine.
7. Compressor wash ring tube assembly at the union forward of aft fireseal.
8. Fuel inlet manifold adaptor dump tube at front fireseal.
9. Fuel inlet hose at the oil-to-fuel heater.
10. Fuel purge hose at the start control unit.
11. Oil pressure line at engine.
12. Engine overboard breather hose at engine.
13. High-pressure fuel pump drain.
14. Fuel pressure line from rear of oil to fuel heater.
15. Torque indicating systems hoses at aft fireseal.
C. Connect the electrical leads and connector plugs at the locations noted:
1. Engine ground cable to rear of engine-driven boost pump.
2. Fuel flow transducer (if equipped).
3. Starter/generator terminal block.
4. Ignition leads at exciter box.
5. Oil temperature-sending unit.
6. Ng tach generator.
7. Tq pressure transmitter (if equipped).
4 – 11
THRUSH AIRCRAFT INC - T660 TURBO THRUSH
AIRCRAFT MAINTENANCE MANUAL
* NOTE *
Route forward electrical harness through forward close
out. Install grommet in slot provided. Secure harness to
basket structure as previously noted. Connect harness
to items as follows.
Effective: 12/17/03