Metal Empennage - Thrush Aircraft S2R–T660 Maintenance Manual

Check the travel of the movable surfaces.
Elevator up
Elevator down
1.
Rudder
Tab up
Tab down
Check for warped contours of the fixed surfaces due to
2.
improperly tightened brace struts.
Inspect horizontal stabilizer "V" struts, fittings, and hardware
3.
for security, cracks and corrosion.
Inspect electric rudder trim systems rod-ends, bell-crank,
electric linear actuator attachment hinge, trim tab, and trim tab
hinge for lubrication, general condition, and security. (Note:
4.
No maintenance required or recommended for the electric
linear actuator.)
Inspect all hinges for wear. Replace sealed bearings, if
5 .
needed.
6. Check security of all bolts.
7. Check the external skins for general condition.
8. Check the drain holes for obstruction.
INTENTIONALLY LEFT BLANK
2 – 32
THRUSH AICRAFT INC - T660 TURBO THRUSH
AIRCRAFT MAINTENANCE MANUAL

METAL EMPENNAGE

27 degrees ±1 degree
17 degrees ±1 degree
22 degrees ±1 degree
8 degrees ±1 degree
22 degrees ±1 degree
50 100
Daily
HRS HRS
X
X
X
X
X
X
X
X
Effective: 12/17/03
400
HRS
X
X