Rudder Installation; Rudder Pedal Removal; Control Cables Removal; Control Cables Installation - Thrush Aircraft S2R–T660 Maintenance Manual

B. Remove attaching hardware from rudder hinge points.
C. Remove the rudder from the aircraft.

RUDDER INSTALLATION

A. Place rudder on hinge points.
B. Install the hardware in the hinge.
C. Attach rudder cables to rudder horn.
D. Check rudder operation to determine that no friction or binding is evident.
E. Readjust control cables and rudder stops as required per rigging instructions.

RUDDER PEDAL REMOVAL

Use Figure 7-7 as a guide when removing or installing rudder pedals.

CONTROL CABLES REMOVAL

A. Disconnect the aft cables from forward side of shackles.
B. Remove skins from side of fuselage.
C. Disconnect cables at turnbuckles.
D. Remove all cable guards from the rudder cable pulleys and disconnect the aft cables from
rudder horn. The cables from the turnbuckles aft are free for removal.
E. Disconnect cables from adjustment channel. The cables from the turnbuckles forward to
the pedals are free for removal.
F. Remove the balance cables.
G. Remove rudder-aileron cable from aileron vertical bellcrank.
CONTROL CABLES INSTALLATION (Fig. 7-6)
A. Install the cables in reverse order of the removal procedures.
B. Check rigging per rigging instructions.
C. Assure all cables, cable guards and turnbuckles are installed properly and safety wired. Replace all
skins removed for access.

RUDDER RIGGING

A. Position the rudder pedals at mid-adjustment position in the adjustment channel.
Effective: 12/17/04
THRUSH AIRCRAFT INC - T660 TURBO THRUSH
AIRCRAFT MAINTENANCE MANUAL
7 - 8