Dab Operation; Dab Auto Scan; Secondary Services - Logik L66DAB11 Instruction Manual

DAB Operation

If the unit is connected to the mains power and then switched on from
standby for the first time, the unit will automatically enter into DAB
mode and perform the auto scan function. During the scan the display
will show "Scanning ..." together with a slide bar that indicates the
progress of the scan and the amount of stations that have been found
so far.
Once the scan has finished, the unit will select the first
alphanumerically found station. To explore the found stations by
pressing the buttons. When you find a station that you would like
to listen to, press the SELECT button.
If no stations are found after auto scan, the unit will then enter into the Tune
Select Menu. Press the
manual tune or auto scan modes for stations.

DAB Auto Scan

The auto scan will search for the entire DAB Band III channels. After the scan has finished, the
first alphanumerically found station will be automatically selected.
Full auto scan will not replace the DAB stations in the memory. If you want to
remove all the previously scanned stations, you will need to reset the system.
To activate auto scan, first press the MENU button to enter the
1.
Tune Select Menu. Press the
then press the SELECT button to confirm. The display will show
"Scanning ..." and a slide bar that indicates the progress of the
scan.
2. All the stations that have been found will be stored automatically.
To explore the found stations, press the
press the SELECT button to confirm.

Secondary Services

You may see a ">" symbol after the name of the station when pressing the
explore searched stations. This indicates that there are secondary services available to that
station. These secondary services contain extra services that are related to the primary station,
e.g. a sports station may want to add extra commentaries. The secondary services are inserted
directly after the primary station in the station list.
To select the secondary station, press the
is displayed, then press the SELECT button. When the secondary service ends, the unit will
automatically switch back to the primary station.
buttons and then press the SELECT button to select
buttons to select "Autoscan",
buttons and then
buttons until the desired secondary station
buttons to
13