Table of Contents
Advertisement
DAB Operation
If the unit is connected to the mains power, the ON/OFF switch at the rear is switched
to the ON position and then press the STANDBY/ON button to switch the unit on
for the first time, the unit will automatically enter into the DAB mode and perform
quick scan function. During the scan the display will show "Searching..." together
with a slide bar that indicates the progress of the scan and the amount of stations
that have been found so far.
Once the scan has finished, the unit will select the first alphanumerically found
station. To explore the found stations, press the SKIP/TUNE SEARCH
Quick Scan
1. Press the PLAY/PAUSE/SCAN
from 10A to 12D.
2. All the stations that have been found will be stored automatically. To explore
and listen to the found stations, press the SKIP/TUNE SEARCH
select.
Full Scan
The full scan will search the entire DAB Band III channels. After the scan has finished,
the first alphanumerically found station will be automatically selected.
1. To activate full scan, press and hold the PLAY/PAUSE/SCAN
Autotune Full scan mode, the display will show "Searching..." and a progressing
slide bar.
2. All the stations that have been found will be stored automatically. To explore
and listen to the found stations, press the SKIP/TUNE SEARCH
select.
Manual Tuning
As well as the auto tune function, you can manually tune the receiver. This can help
you when aligning your aerial or when adding stations that were missed while auto
tuning.
1. Press the SELECT/FM MONO/ST. button to select Manual tune mode.
2. Press the SKIP/TUNE SEARCH
which are numbered from 5A to 13F.
3. After your desired channel number is selected, the display will show the multiplex.
Press the SELECT/FM MONO/ST. button to confirm.
4. Press the SELECT/FM MONO/ST. button to exit Manual tune mode.
button to start quick scan for popular channels
buttons to cycle through the DAB channels,
buttons.
buttons to
button to enter
buttons to
17
Advertisement
Table of Contents
