Alarm Settings - GeoVision GV-BX2400-1F Firmware User Manual

[Upload to an FTP Server]
Enable: Select to enable the FTP function and then select Active
Mode or Passive Mode, depending on the setting of your FTP server.
Server URL/IP Address: Type the URL address or IP address of the
FTP Server.
Server Port: Type the port number of the FTP Server. Or keep the
default value 21.
User Name: Type a valid username to log into the FTP Server.
Password: Type a valid password to log into the FTP Server.
Remote Directory: Type the name of the storage folder on the FTP
Server.
Alerts Interval time in minute: Specify the interval between FTP
alerts. The interval can be between 0 and 60 minutes. The option is
useful for the frequent event occurrence by which any event triggers
during the interval period will be ignored.

[Alarm Settings]

Motion Detection: When a motion is detected on the camera, a still
image will be sent to the FTP Server.
Continuously send images upon trigger events (motion): A
sequence of snapshots is uploaded to the FTP Server when a
motion is detected. This stops as soon as no motion is detected.
Digital Input: Note this function is only supported by cameras with
I/O function. Once the input is triggered, a still image will be sent to
the FTP Server.
Continuously send images upon trigger events (input): A
sequence of snapshots is uploaded to the FTP Server when the
input is triggered.
Continuously send images: Sends images to the FTP server at the
specified interval.
4 4
Administrator Mode
113