Motion Detection - GeoVision GV-BX2400-1F Firmware User Manual

4.2.1 Motion Detection

Whenever movement is observed in the detection region, you will be
alerted by an alarm or a notification. The alarm output will be set off, e-mail
and FTP upload will be triggered, and the connected surveillance system
GV-VMS, GV-Center V2 and GV-Vital Sign Monitor will record the event.
You can configure up to 3 areas with different sensitivity values for motion
detection.
1. From the Video Analysis drop-down list, select Motion Detection.
This page appears.
2. Select Enable.
3. If you want to invoke an alarm output when motion occurs, select
Trigger digital output relay. For this function, you need to set up an
output device in advance, see 4.3.2 Output Settings.
Figure 4-12
4 4
Administrator Mode
85