Preparation For The Dive And Function Check; Functions During The Dive; Immersion; Setting Bookmarks - Uwatec Aladin TEC 3H User Manuals

Table of Contents

Advertisement

4.3.2 Preparation for the dive and function check

Check the battery capacity before each dive ->15.

4.4 Functions during the dive

4.4.1 Immersion

If the water contacts are deactivated (->70), switch on Aladin TEC 3H before immersion.
If you have chosen the option "Water contacts off" ("set 1" or LogTRAK), Aladin TEC 3H will turn on
with a delay of up to 1 minute into the dive. This will affect functioning of the computer. Make sure
that the computer is on before starting the dive.
After immersion, starting at a depth of about 0.8m (3ft), all diving functions are monitored, i.e. depth,
tank pressure and dive time displayed, maximum depth stored, saturation of tissues calculated,
no-stop time or decompression prognosis determined, ascent rate controlled and displayed and the
correctness of the decompression procedure supervised.

4.4.2 Setting bookmarks

During the dive you can create bookmarks in your dive profile by pressing
appears for 4 seconds and an audible signal confirms the creation of the bookmark. These bookmarks
will be graphically displayed in the dive profile of LogTRAK.

4.4.3 Dive time

Dive time
Half time alarm (turn around alarm)
If half of the set maximum dive time has elapsed, an audible signal goes off and
Set dive time has elapsed ->69
An audible signal goes off and the dive time starts flashing.
Switch on Aladin TEC 3H by pushing
all elements of the display activated? Do not use Aladin TEC 3H if the display
does not show all elements. When switching on Aladin TEC 3H with
the test display will not appear.
WARNING
WARNING
The whole time spent below a depth of 0.8m (3ft) is displayed as dive time
in minutes. The time above 0.8m (3ft) is counted as dive time only if the diver
descends again below 0.8m (3ft) within 5 minutes.
While the dive time is running, the colons on the right of the figures are flashing
in one second intervals. Maximum dive time displayed is 199 minutes.
WARNING
WARNING
Functions during the dive
and check the test display: Are
. The logbook icon
flashes for 1 minute.
,
23

Advertisement

Table of Contents
loading

Table of Contents