Preparation For The Dive; Setting The Gas Mixture And Ppo Max; Preparation For The Dive And Function Check - Uwatec Aladin SPORT User Manual

Preparation for the dive

3 Preparation for the dive
You have to check the settings of SPORT especially before the first dive. All settings can be checked
and changed directly at SPORT or via LogTRAK.
3.1 Setting the gas mixture and ppO
Before every dive and after changing the tank, make sure that the settings for the gas mixture
correspond with the current mixture used. An incorrect setting causes SPORT to miscalculate this
particular dive. If the fraction of oxygen is set too low this can lead to oxygen poisoning without
warning. If the value is set too high decompression sickness may occur. Inaccuracies in the
calculations are carried over to repetitive dives.
or until
Max Operating
Depth MOD
Change the O % mix by
2
(+) and
(–)
ppO
Change the ppO2 max by
(+) and
• Without confirmation the display will disappear after 3 minutes and your entries will not
be accepted.
• Automatic reset of the O
between 1 and 48 hours or to "no reset" (default).

3.2 Preparation for the dive and function check

Check the battery capacity before each dive ->14.
20
max
2
! WARNING
To set the gas mixture, SPORT must be in user mode (time of day display).
1. Push
appears.
2. Confirm that you wish to change the displayed oxygen fraction by
pushing
3. Change the oxygen fraction in increments of 1% by pushing
or
the maximum partial pressure limit (ppO
4. Confirm the selected percentage with
max
2
5. By pushing
chosen fraction of oxygen down to 1.0bar. SPORT will now display
the corresponding MOD for the new ppO
6. Confirm your ppO
(–)
% mix to 21% can be set with "set 1" ->32 or LogTRAK
2
Switch on SPORT by pushing
elements of the display activated? Do not use SPORT if the display does not
show all elements. When switching on SPORT with
will not appear.
! WARNING
or until the symbol for the setting of the O
.
. SPORT will display the current fraction of oxygen,
or you can change the ppO
max settings with
2
and check the test display: Are all
mixture
2
max) and the MOD.
2
.
max for the
2
max.
2
.
, the test display