Table of Contents
Advertisement
8.2.1 Connecting the high pressure hose
WARNING
•
Avoid dropping or jarring your Aladin TEC 3H.
•
Do not allow your Aladin TEC 3H to be exposed to direct, intense
sunlight.
•
Rinse your Aladin TEC 3H thoroughly with fresh water after each dive.
•
Do not store your Aladin TEC 3H in a sealed container; make sure
there is free ventilation.
•
If there are problems with the water contacts, use soapy water to clean
Aladin TEC 3H and dry it thoroughly. The surface of your Aladin TEC
3H housing can be treated with silicone grease. Do not apply grease
to the water contacts!
•
Do not clean Aladin TEC 3H with liquids containing solvent (apart from
water).
•
Check the battery capacity before each dive ->15.
•
If the battery icon appears, replace the battery ->76.
•
Diving with a weak battery: Aladin TEC 3H may stop working during
the dive, service icon and error code "E3" or "E6" appear. Close the
dive and replace the battery ->76.
•
On the surface: if service icon and error code "E3" appear, replace the
battery ->76.
All error codes other than E3: Aladin TEC 3H must not be used for
any further dives. Take your dive computer to an authorized Scubapro
dealer.
Aladin TEC 3H may only be used with Scubapro high pressure hose. If you
need to remove or reconnect the high pressure connection, two wrenches
must be used as shown in the figure.
When connected directly to a high pressue hose, be sure that the swivel is
inserted with proper size and material O ring.
When quick release system is assembled, the O-ring between the bayonet
and TEC 3H replaces the swivel.
Quick release system attached to the Aladin TEC 3H is shown at the picture.
Be sure that high pressure is not applied when connecting or disconnecting the
Aladin TEC 3H from the quick release.
The bayonet must be fully pushed in when cover is twisted to locking
position. In the correct locking position the bayonet moves forward approx
4mm (1/5 of an inch) and stays securely locked. Apply the high pressure
to the system only after quick release has been correctly closed.
Appendix
75
Advertisement
Table of Contents
