Advertisement
II. Setup
a) Once the unit is turned ON, by pressing the green button
corner, the unit powers up and defaults to the Waveform Mode
frequency. This function is the top-right of the six blue main mode function buttons
bullet 9). Date, time and battery capacity are displayed in the top-right-corner of the screen
b) The user can depress the SETUP button
(Figure 1 bullet 10). There are 11 options in the setup. One option to note is the Electrical Hookup. Use the
down arrow keys
(Figure 1, bullet 9). You should see a screen similar to Figure 2. Figure 3 shows the example of the screen seen
while configuring the instrument using the DataView
Figure 2. PowerPad™ setup screen
To change the setup using the panel, simply scroll through the options using the arrow keys
bullet 8) and pressing the ENTER key
3
www.aemc.com
.
, the top button on the left side, to configure the instrument
(Figure 1, bullet 8) to scroll down to the desire function and press the ENTER key
(Figure 1, bullet 9) when the desired function is highlighted.
(Figure 1, bullet 11) in the bottom-left-hand
®
software.
®
Figure 3. Dataview
setup screen
Technical Assistance (800) 343-1391
showing the waveform icon and
(Figure 1,
(Figure 1,
Advertisement
