Garmin GTN 625 Pilot's Manual page 484

15.12
Foreword
The GTN can also configure the Bluetooth transceiver in other units, such as
Getting
the GTX 345.
Started
Audio &
Xpdr Ctrl
Com/Nav
Touch To Set
FPL
The Bluetooth
Name
Direct-To
Proc
From the Connext Setup page, the pilot can enable/disable Bluetooth, change
Wpt Info
the Bluetooth name, and manage paired devices. On the Paired Devices page,
the device status indicates if the portable device is paired and connected. To
Map
connect a different device when the maximum number are already connected,
the existing connection must be ended by removing the portable device pairing
Traffic
or by disconnecting or disabling Bluetooth on the portable device. Removing a
device from this page by pressing "Remove" will require the device to be paired
Terrain
again before reconnecting.
Weather NOTE: If the pairing is removed from either device (portable device or
installed avionics) it must be removed on the other device before a new
pairing to that same device is established again. Essentially, the pairing
Nearest
must be removed on both devices before re-pairing.
Services/
Music
New devices can only be paired while the unit is in "Pairing Mode." Pairing
mode is active while on the Connext Setup page or the Manage Paired Devices
Utilities
page. The pairing must be initiated by the portable device. A pop-up will be
displayed on the portable device to confirm the pairing.
System
Messages
Symbols
Appendix
Index
15-48
Connext Setup - Other Bluetooth Devices
Figure 15-67 Connext Setup for GTX 345
Garmin GTN 625/635/650 Pilot's Guide
Touch To Enable
Bluetooth
Touch To Manage
Paired Devices
190-01004-03 Rev. K