Garmin GTN 625 Pilot's Manual page 168

Foreword
Getting
Started
Audio &
Xpdr Ctrl
Com/Nav
FPL
Direct-To
Proc
7.7.1
If an external Mark On Target (MOT) switch is installed, pressing that switch
Wpt Info
will result in the creation of a User waypoint called MOTxxx at the point in space
Map
where the MOT switch was pushed. The waypoints are created in increasing
numeric order up to number 999, at which point they will start replacing
Traffic
existing waypoints at the beginning of the list.
When a Mark on Target waypoint is created, it may not be immediately
Terrain
visible on the moving map page because the ownship icon will be directly on
top of the waypoint. Creation of the waypoint can be verified by changing zoom
Weather
scales on the map or viewing the User Waypoints page.
Nearest
NOTE: This feature is available in software version 4.00 and later.
Services/
Music
7.7.2
Utilities
System
Messages
Symbols
Appendix
Index
7-16
Touch to Select the
Desired Waypoint
Reference Type
Figure 7-23 Waypoint Info - Create User Waypoint Type
6. If desired, touch the Temporary? key to create the waypoint
for only temporary use. Temporary waypoints will be removed
when the power is cycled.
7. When finished with all selections, touch the Create key to
create the new waypoint.
Mark On Target
Waypoint Location Based on Lat/Lon
Coordinates
1. From the Create User Waypoint page, touch the Position
key and then the Lat/Lon key. Then, touch the Latitude/
Longitude value key.
Figure 7-24 Waypoint Info - Create User Waypoint Type - Lat/Lon
Garmin GTN 625/635/650 Pilot's Guide
Touch to Select
Lat/Lon Waypoint
Reference Type
Touch to Select
Lat/Lon Values
190-01004-03 Rev. K