Stopping Image Acquisition; Rebooting A Camera; Saving And Restoring Camera Settings; Saving Camera Settings - Dalsa QuickCam User Manual

QuickCam User's Manual
2.
The camera is now grabbing images in continuous mode.
From here you can also select whether or not to allow bad and/or incomplete
images to be acquired by selecting the Bad image passthrough and Ignore
Missing Packets options.
To switch between continuous mode and snapshot mode:
1.

Stopping Image Acquisition

To stop acquiring images:
1.
2.
Toolbar equivalent:

Rebooting a Camera

To reboot the camera:
1.
2.
Toolbar equivalent:

2.4 Saving and Restoring Camera Settings

Saving Camera Settings

You can save the current camera settings to the camera's non-volatile memory,
allowing you to use them again after a camera reboot.
03-032-10187-04
Under Acquisition Control:
Click the Start button.
Click the button to continuously grab images
or
Click the button to take a snap shot of the image.
Open the Connection tab in the Camera Configuration Window.
Under Device Actions:
Click the Stop button.
Open the Connection tab in the Camera Configuration Window.
On the Connect/Detect tab:
Click the Reset Camera button.
10
DALSA corp.