Time-Outs & Packets Dialog Box - Dalsa QuickCam User Manual

73
Time-outs & Packets Dialog Box
Use Configure
box.
Command
Command Retries
Answer Timeout
First Packet
Timeout
Packet Timeout
Request Timeout
03-032-10187-04
Advanced Ethernet to open the Time-outs & Packets dialog
Purpose
Indicates the maximum number of retries to perform
when a command is sent from the PC to camera. A
command consists of a single command packet from the
PC and an acknowledge packet from the camera. If
either of these packets is lost, the behavior of QuickCam
remains the same because it does not receive the
acknowledge packet. Before issuing a time out error,
however, the software will resend the command packet.
The value of this parameter indicates the maximum
number of tries (including the original command) that
the underlying communication layer will attempt.
Indicates the maximum time, in milliseconds, that the
camera can take to respond to a command from
QuickCam.
Indicates the maximum time, in milliseconds, that the
camera can take to send the first packet of image data to
the application. When it is zero, the timeout is
calculated automatically from the request timeout.
Indicates the maximum time, in milliseconds, the
camera can take to send subsequent packets of image
data to QuickCam. When it is zero, the timeout is
calculated automatically from the request timeout.
Indicates the maximum time, in milliseconds, the
camera can take to send all the packets of image data to
QuickCam.
QuickCam User's Manul
.
DALSA corp.