Loading Camera Configuration From An Xml File; Saving, Loading, And Resetting Pixel Coefficients - Dalsa QuickCam User Manual

QuickCam User's Manual
Toolbar equivalent:
A camera script file is created with the specified file properties.
Loading Camera Configuration from an XML
File
You can load camera system settings from a previously saved XML file. This is
useful when you want to load the same settings on multiple cameras.
To load Ethernet configuration settings from an XML file:
1.
2.
3.
4.
Toolbar equivalent:
Saving, Loading, and Resetting Pixel
Coefficients
You can save the current FPN and PRNU coefficients to the camera's non-volatile
memory, allowing you to reload and re-use the coefficients again at a later time.
You can also reset pixel coefficients to zero at any time.
To save or load pixel coefficients:
1.
2.
3.
The selected pixel coefficient set is now saved or loaded.
effect on your image. Refer to 7.7 Enabling and Disabling Coefficients for details.
To reset pixel coefficients to zero:
1.
03-032-10187-04
Choose File → Load XML File....
In the Open dialog box:
In the Look in list, click the drive, folder, or Internet location that contains
the file you want to open.
In the folder list, locate and open the folder that contains the file.
Click the file, and then click Open.
Open the Save/Restore tab in the Camera Configuration Window.
Under Pixel Coefficients:
Select the pixel coefficient set number from the Set Number drop down box.
You can save or load up to four different sets of pixel coefficients.
Click Save or Load.
Remember that pixel coefficients must be enabled in order to see their
Open the Save/Restore in the Camera Configuration Window.
Under Pixel Coefficients:
12
DALSA corp.