Dalsa QuickCam User Manual page 45

43
Up Event
Specifies how the input for incrementing the count is handled. The counter's up
event uses the Q17 label in the LUT. It can be one of the following settings:
•
•
•
•
•
•
Down Event
Same as above but for the down event, but uses the Q16 label in the GPIO LUT.
Clear Event
Same as above but for the clear event. The clear event input of the counter does
not have a predefined label on the GPIO LUT.
Input
03-032-10187-04
Disabled
On the rising edge
On the falling edge
On both edges
On the high level
On the low level
QuickCam User's Manul
DALSA corp.