CTS HES-3106 Series User Manual

CTS HES-3106 Series User Manual

6 ports 10/100/1000base-t managed ethernet switch; 5 ports 10/100/1000base-t and 1 port 1000base-x or 100/1000base-x uplink managed ethernet switch; 5 ports 10/100/1000base-t and 1 port 1000base-x or 100/1000base-x uplink management ethernet switch with

Advertisement

HES-3106 SERIES
6 PORTS 10/100/1000BASE-T MANAGED ETHERNET SWITCH
5 PORTS 10/100/1000BASE-T AND 1 PORT 1000BASE-X OR
100/1000BASE-X UPLINK MANAGED ETHERNET SWITCH
5 PORTS 10/100/1000BASE-T AND 1 PORT 1000BASE-X OR
100/1000BASE-X UPLINK MANAGEMENT ETHERNET SWITCH
WITH CATV RF MODULE
User's Guide
Version 1.0

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the HES-3106 Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for CTS HES-3106 Series

  • Page 1 HES-3106 SERIES 6 PORTS 10/100/1000BASE-T MANAGED ETHERNET SWITCH 5 PORTS 10/100/1000BASE-T AND 1 PORT 1000BASE-X OR 100/1000BASE-X UPLINK MANAGED ETHERNET SWITCH 5 PORTS 10/100/1000BASE-T AND 1 PORT 1000BASE-X OR 100/1000BASE-X UPLINK MANAGEMENT ETHERNET SWITCH WITH CATV RF MODULE User’s Guide...
  • Page 2: Copyright Statement

    Trademarks CTS is a registered trademark of Connection Technology Systems Inc.. Contents subject to revision without prior notice. All other trademarks remain the property of their respective owners. Copyright Statement Copyright  2012 Connection Technology Systems Inc.. This publication may not be reproduced as a whole or in part, in any way whatsoever unless prior consent has been obtained from Connection Technology Systems Inc..
  • Page 3: Table Of Contents

    Table of Contents 1. INTRODUCTION ................... 4 1.1 The Managed Ethernet Switch ..............4 1.2 Appearance ....................5 2. INSTALLATION ..................... 8 2.1 Installation Requirements ................. 8 2.2 Checking the Package Contents .............. 8 2.3 Installing the Managed Switch ..............9 2.4 Powering ON ....................
  • Page 4: Introduction

    1. INTRODUCTION Thank you for choosing this Managed Ethernet Switch. The Managed Switch can provide the best performance and price ratio when multiple copper ports need to be deployed in networking environment. 1.1 The Managed Ethernet Switch With 5 or 6 10/100/1000Mbps RJ-45 ports on the front panel, this compact Managed Switch provides high performance store-and-forward switching capability plus other advanced features such as QoS, VLAN, etc..
  • Page 5: Appearance

     Management:  Telnet/SSH/SNMP/Web interface  Storm Control  DHCP Client  DHCP Auto-Provisioning  Text Based Config  SFF-8472 (digital diagnostic management interface for SFP)  Power Down Trap  RMON:  FTP/TFTP upgrade 1.2 Appearance Front Panel ➊ ➋...
  • Page 6: Rear Panel

    Rear Panel Figure 3. Rear Panel for 6 Ports 10/100/1000Base-T Management Ethernet Switch ➎  Figure 4. Rear Panel for 5 Ports 10/100/1000Base-T and 1 Port 1000Base-X or 100/1000Base-X Uplink Management Ethernet Switch with CATV RF Module  100/1000Mbps or 1000Mbps F/O Port ➎...
  • Page 7: Top Panel

    Top Panel ➑ Figure 7. Top Panel ➑ LED: For detail definitions, please refer to chapter 3.1 LED Definitions Cable Specifications The following table contains various cable specifications for the Managed Switch. Please make sure that you use the proper cable when connecting the Managed Switch.
  • Page 8: Installation

    2. INSTALLATION To properly install the Managed Switch, please follow the procedures listed below. Procedures covered in this chapter are described below in separate sections.  Installation Requirements  Unpacking the Managed Switch  Installing the Managed Switch  Powering on the Managed Switch ...
  • Page 9: Installing The Managed Switch

    2.3 Installing the Managed Switch CAUTION To prevent any damage or failure of the Managed Switch, please DO NOT block the ventilation FAN holes. Use the following guidelines when choosing a place to install the Switch:  Firm and steady flat surface. ...
  • Page 10: Connecting The Switch To Network

    2.5 Connecting the Switch to Network Connect to Network This Managed Switch has 5 or 6 10/100/1000Mbps RJ-45 ports on the front panel. These ports can be inserted by 10/100/1000Base-T cables, connecting to the end devices. The connection of the fiber port on the rear panel must be matched, i.e.
  • Page 11: Operation

    3. OPERATION The Managed Switch is Plug & Play compliant. Real-time operational status can be monitored through a set of LED indicators located on the top panel. A built-in management module provides users with flexible interfaces to configure, control and monitor the complete system remotely. 3.1 LED Definitions Definition Color...
  • Page 12: Maintenance

    4. MAINTENANCE It is easy to use and maintain this Managed Switch. The procedures are suggested when you want to identify faults, perform hardware replacement and firmware upgrading. 4.1 Fault Identification Identifying faults can greatly reduce the time required to find the problem and solution.
  • Page 13: Hardware Replacement Procedures

    4.2 Hardware Replacement Procedures WARNING! The Managed Switch contains no user-serviceable parts. DO NOT, UNDER ANY CIRCUMSTANCES, open and attempt to repair it. Failure to observe this warning could result in personal injury or death from electrical shock. Failure to observe the above warning will immediately void any Warranty. 4.3 Firmware Upgrade This Managed Switch may perform firmware upgrading when required.

Table of Contents

Save PDF