Glossary - MGE UPS Systems Pulsar EXtreme2000 Installation And User Manual

Up to 3000va
Table of Contents

Advertisement

6.1 Glossary

Authorized voltage
range for transfer to
bypass if fault or overload
Automatic bypass
Automatic start following
return of AC input power
Backup time
Bargraph
Battery test
CLA (Long backup-
time charger)
Cold start
Connection module
Dialog box
Double conversion
Equipment
Fault tolerant
Forced shutdown
Upper and lower voltage thresholds within which the UPS can operate
on the automatic bypass in the event of a UPS fault or overload.
Automatic switch controlled by the UPS, used to connect the equipment
directly to the AC-power source.
When AC input power returns following shutdown at the end of the battery
backup time, UPS automatic start can be enabled or disabled.
Time that the connected equipment can operate on battery power.
Device on the front panel indicating the percent remaining backup time
or the percent load.
Internal UPS test on battery status.
Module incorporating a charger for long backup times. The charger is powerful
enough to charge battery extension modules offering very long backup times.
See "Start on battery power".
Unit grouping the receptacles for connection to the AC-power source
and the equipment.
A window in a computer program displayed for selection by the user of various
options and parameter settings.
The power supplied to the connected equipment is completely regenerated
by continuous double conversion, i.e. the AC power from the AC-power source
is rectified (AC - DC), then converted back (DC - AC) to AC power.
Devices or systems connected to the UPS output.
Connection module (without manual bypass) offering receptacles
for connection to the AC-power source and the equipment.
Allows a "clean" of computer operating systems depending on the low battery
threshold setting. If the input source is restored during the time period
between the shutdown order and actual system shutdown, it causes a
voluntary interruption of the supply of power to the connected equipment
(lasting 10 seconds) after system shutdown.
6. Appendices
- Page 31
51033211EN/AC

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pulsar extreme3000

Table of Contents