Safety Regulations - SEH OMD User Manual

Safety Regulations

Before starting the initial setup procedure and during the operation of the OMD,
please note the following safety regulations. Their purpose is to protect yourself
and others from personal injuries, and avoid damage to the equipment:
Read the documentation and make sure that your system meets the
requirements listed therein.
The OMD may only be connected to the mains and to the network by qualified
personnel.
Do not open the housing of the device. The OMD may only be connected and
operated if the housing is not opened and if the OMD is in perfect condition.
Do not put objects on top of the housing.
The OMD must be placed on a solid surface with no vibration. The device must
not be operated in dusty places and direct sunlight.
Avoid contact with humidity or liquids.
The OMD may only be connected and operated if the installation location
meets the ambient conditions; see: 'Technical Data'
If the supplied power cord cannot be used in your country, acquire an
appropriate power cord that suits national provisions. For more information,
please consult your retailer.
Make sure that no-one steps on or stumbles over the cables.
The OMD must be connected to a socket with protective contact.
Position the OMD in a way that guarantees that the socket for the connection
of the power cord is in the proximity of the device and is easily accessible.
Make sure that the device can be separated easily from the network. A
damaged power cord must be replaced immediately. For more information,
please consult your retailer.
Do not connect a telephone cable to the RJ-45 connector. The RJ-45
connector may only be connected to SELV voltages. For the connection to the
RJ-45 connector only STP cabling (category 5 or better) may be used. The
shielding must fit flushly to the connector.
Use a certified USB Hi-Speed cable to connect the printer. A list of cables may
be founde at www.usb.org !
6 [en]
5.
User Manual