Life Fitness UPRIGHT LIFECYCLE Operation Manual page 8

The individual human power required to perform an exercise may be different than the mechanical power
displayed on the Cross-Trainer and FlexStrider.
Use caution when mounting or dismounting the Cross-Trainer and FlexStrider. Before mounting, use the moving
arms to bring the pedal nearest to you to the lowest position. Use the stationary handlebars whenever additional
stability is required. While exercising, hold onto the moving arms.
Never face backward while using the Cross-Trainer or FlexStrider.
LIFECYCLE EXERCISE BIKES
WARNING:
objects on either side. Provide at least 3 ft. (0.9 m) between the front or rear of the Life Fitness bike to any other
objects and 2 ft. (0.6 m) in the direction the equipment is accessed from.
Do not stand or sit on plastic shrouds.
Use caution when mounting or dismounting the Lifecycle Exercise Bike. Use the stationary handlebar whenever
additional stability is required.
POWERMILL CLIMBER
WARNING:
and 1 ft. ( 0.3 m ) on each side.
Handrails may be held to enhance stability as needed, but are not for continuous use.
The product should never be left unattended when plugged in. Disconnect from the electrical outlet when not in
use, and before putting on or taking off parts.
plug from electrical outlet.
Never walk or jog backwards on the PowerMill Climber.
Unlike bikes, cross-trainers, or the traditional paddle stairclimbers, this is a motorized product. This motorized
product causes stair steps to descend at variable rates and therefore operates on different planes simultaneously.
While operating the product during a typical workout, the user is forced to fully concentrate on coordinating his or
her efforts on the moving stairs. Therefore, the user cannot see if anyone or any thing approaches from the rear.
For these reasons this unit is designed for use only in a controlled setting. The PowerMill Climber is not
designed for use in the home and should not be used in an environment where children or animals might
have access.
When it is necessary to immobilize the product, set the display to read SELECT WORKOUT. (Press the PAUSE /
STOP key twice if not already there.) Hold down the LEVEL DOWN arrow key and press the PAUSE / STOP key.
The product now displays "IMMOBILIZED". The product can't be operated in this state. The motor is disabled. The
product will remain in this state across resets, power cycles, etc. To restore normal operation, repeat the same
key sequence: hold down the LEVEL DOWN arrow key and press the PAUSE / STOP key. The product will dis-
play "SELECT WORKOUT".
SAVE THESE INSTRUCTIONS FOR
Allow a distance of 16 in. (41 cm) between the widest part of the bike and other
Allow at least 3 ft. (1 m) of clearance behind the Life Fitness PowerMill Climber
FUTURE REFERENCE.
To disconnect, turn power OFF at the ON/OFF switch, then remove
7