Selecting And Installing Bracket; Installing The Disk Array Controller - NEC Promise SuperTrak EX8350 User Manual

22

5-2. Selecting and Installing Bracket

The card is shipped with factory-installed full-height PCI bracket. To install the card on a low-profile PCI slot,
the full-height PCI bracket should be replaced with the low-profile PCI bracket.
Remove the screws (2) fixing the full-height PCI bracket to the card.
1.
Remove the full-height PCI bracket.
2.
Install the low-profile PCI bracket on the card.
3.
Secure the low-profile PCI bracket with the screws (2) removed in step 1.
4.
Use the similar procedure to replace the low-profile PCI bracket with the
full-height PCI bracket.
Tips

5-3. Installing the Disk Array Controller

Locate the PCI (or PCI Express) slot in which the disk array controller will be installed and remove
1.
the additional slot cover.
Notice
Some limitation may be imposed to the installation on the PCI (or PCI Express) slot
depending on the type of the server. Before the installation, check the limitation following
the User's Guide of the server.
Check
Insert the card into the PCI (or PCI Express) slot securely and fix it. To fix the card with screws, use
2.
the screw removed from the additional slot cover.
Keep the removed additional slot cover for future use. The removed screw will be used
to install the card. Do not lose them.
The card does not support the PCI hot-plug feature. Before installing or removing the
card from the server, always power off the server and pull out the power cord from the
receptacle.
Full-height PCI bracket
Low-profile PCI bracket