Camera Lens Adjustment - Bosch KBN Series Installation Manual

KBN & KBE Series Cameras
7.
8.
9.
6.4

Camera Lens Adjustment

The camera and lens come factory-configured and ready for
operation. If custom setup is required, see the camera
Installation Instructions included in the Instruction Booklet
Packet.
Figure 6.8 Removing the Bracket
Bosch Security Systems, Inc.
Available from A1 Security Cameras
www.a1securitycameras.com email: sales@a1securitycameras.com
Connect the Cat5 / Cat6 cable to the network connector
on the back of the camera. See Figure 6.4.
If an unterminated Cat5/Cat6 cable is being used, a fitting
may be used in the mounting foot of the camera housing.
The network cable should be terminated with an RJ-45
connector in accordance with the connector
manufacturer's recommendations.
Seal the hole in the mounting foot of the camera housing
with RTV or an equivalent seal. See Figure 6.5. If a fitting
was used in the mounting foot, apply the seal around the
network cable before tightening the fitting, to prevent
slippage. A split rubber sleeve (not supplied) may be used
for this purpose.
Installation Manual
Installation of KBE (Outdoor) Cameras | en
F.01U.215.198 | 4.0 | 2011.01
35