Table of Contents
Advertisement
KBN & KBE Series Cameras
WARNING!
If connecting to a PoE LAN switch, remove the separate AC
power connections from the camera.
Bosch Security Systems, Inc.
Available from A1 Security Cameras
www.a1securitycameras.com email: sales@a1securitycameras.com
Ethernet (item 4 below). Pull the cable through the
NPT fitting to remove.
f.
Insert the user-supplied shielded UTP Category 5
cable with RJ-45 connector through the grommet in
the bottom of the mount.
g.
Route the Ethernet cable through the mount, then out
through the flange at the top of the mount.
h.
Insert the Ethernet cable through the NPT fitting, then
route into the housing.
i.
Attach the user-supplied RJ-45 connector to the back
of the camera.
j.
If power is supplied via a PoE LAN switch, remove the
separate AC power connections from the camera.
k.
Replace the camera bracket and slide the housing
cover over the camera.
l.
Tighten the two captive screws at the back of the
housing to secure the cover.
m. Tighten the NPT fitting at the foot of the camera.
Refer to the LTC 9215/00S Installation Manual for
tightening tolerances.
Installation Manual
Installation of KBN (Indoor) Cameras | en
F.01U.215.198 | 4.0 | 2011.01
25
Advertisement
Table of Contents
