960H IR License Plate Bullet Camera
6
Installation
6.2 Monitor connection
Terminal block
Screw
Terminal
10.16
(0.4)
2.6x3.2
(0.1x0.12)
6.3 Camera adjustment
CAUTION!
To prevent humidity problems, the camera must be installed in
dry conditions. The lens knobs (located on the bottom of the camera)
and protection cap (located on the rear of the camera) provide protection
against water ingress when fully tightened. Therefore never remove or keep
them loosened after installation. Doing so could cause water ingress and/or
condensation on the inside of the camera window
1.
Open the protection cap on the rear of the camera (only needed to access
service monitor connection and OSD control)
2.
Connect service monitor (optional)
3.
Loosen the zoom and focus knob
4.
Adjust zoom and focus
5.
Fasten the zoom and focus knob tightly
6.
Adjust OSD settings (refer to Camera Configuration section)
7.
Disconnect service monitor cable (optional)
8.
Check rubber seal is in place on the protection cap. Close and firmly tighten
the protection cap on the rear of the camera.
Bosch Security Systems
Camera
Terminal block connector
18.2(0.71)
5.08(0.2)
"+","-" Indication
mm
(in.)
User Manual
Installation | en
Female
BNC connector
Ground contact
Signal contact
TV Monitor
Video In
*Sold separately
2012.11
9