Table of Contents
Advertisement
4.
CAMERA ADJUSTMENT
Figure 6 - Adjustment Set Screws
1) Mount and secure the REG-X unit according
to specification (see Section 3).
2) Using the provided hex key, loosen all three
set screws on bracket as shown in Fig 6.
3) Adjust the camera position to properly level
the license plate image as seen on the
monitor.
4) Tighten all the set screws.
Warning!
Do not pan or
twist beyond 360°
Do not tilt beyond
90°
Do not apply
excessive force
when adjusting
16
Advertisement
Table of Contents
