Table of Contents
Advertisement
32
en | Installation of KBE (Outdoor) Cameras
CAUTION!
Ensure that the bend radius of the fiber optic cable is in
accordance with the cable manufacturer's specifications when
dressing the fiber optic cable.
Figure 6.4 Connect the Fiber Optic Cable to the Transmitter
Reference Description
1
2
5.
6.
F.01U.215.198 | 4.0 | 2011.01
www.a1securitycameras.com email: sales@a1securitycameras.com
Fiber optic cable
Video connector on fiber optic transmitter
If an unterminated fiber optic cable is being used, a fitting
may be used in the mounting foot of the camera housing.
The fiber optic cable should be terminated with an ST
connector in accordance with the connector
manufacturer's recommendations.
Seal the hole in the mounting foot of the camera housing
with RTV or an equivalent seal. If a fitting was used in the
mounting foot along with an unterminated fiber optic
cable, apply the seal around the optical cable before
tightening the fitting, to prevent slippage. A split rubber
sleeve (not supplied) may be used for this purpose.
Installation Manual
Available from A1 Security Cameras
KBN & KBE Series Cameras
Bosch Security Systems, Inc.
Advertisement
Table of Contents
