Bosch KBN Series Installation Manual page 24

24 en | Installation of KBN (Indoor) Cameras
F.01U.215.198 | 4.0 | 2011.01
www.a1securitycameras.com email: sales@a1securitycameras.com
come out all the way. Do not remove the bottom two
screws.
b. Grasp the housing's front cap and pull forward. Do
not squeeze the cover itself. This will make it difficult
to slide off the cover.
c. Remove the camera bracket by loosening the two
screws (item 3 below) in the front and back of the
bracket.
d. Disconnect the UTP Video/Ethernet cable from the
back of the camera. Cut off the RJ-45 connector from
the end of the cable.
e. Turn over the housing and loosen the NPT fitting from
the foot of the housing that contains the UTP Video/
Installation Manual
Available from A1 Security Cameras
KBN & KBE Series Cameras
Bosch Security Systems, Inc.