I
CAUTION
Installing and Removing Cards
To configure a two-card module
Directions for connecting the cables are printed on the circuit board.
To configure a two-card module, connect the cables as follows.
1 Disconnect the two cables from J4 and J5 and from J7 and J8 on the
card to go in the upper slot.
To remove a cable from the cable connector on the board, gently pcy the
hard plastic part of the cable assembly away from the connector using a
screwdriver. Do not pull on the soft ribbon part of the cable assembly as
_ _ _ _ _ _ _ _ this can damage the cable assembly.
2 Disconnect the cable from J7 and J8 of the card to go in the lower slot.
J8
J4
Two Card Module
13-8