Commissioning The Mover; Warning Information - Truma Mover SE R Operating Instructions & Installation Instructions

Lay one wire to the control unit (this may have to be short-
ened), crimp the flat connector and then connect as shown in
the wiring diagram.
Lay the second wire to the control unit (this may have to be
shortened), crimp the ring lug and then screw to the negative
terminal of the battery as shown in the wiring diagram.
The connection to the control unit follows the following
sequence – nut, ring lug, negative battery connection,
nut, ring lug cable safety socket, nut.
Re-check whether all cables are correctly connected, attached
using the provided clips and cannot chafe.
Commissioning the Mover®
Ensure the battery used to operate the Mover® is fully
charged.
Park the caravan outside on an open, level surface and apply
the handbrake. Ensure that the rollers are disengaged from
the road tyres and the corner steadies are raised.
Connect battery terminals to battery, check that all cables are
secure and not hot or indicating signs of short circuits, etc.
Plug the 13-pin plug into the safety socket.
If there is a fault in both caravan brake lights, the power
circuit of the safety socket is not closed. In this case the
Mover® cannot be operated.
Move slide switch on remote hand set to the "On"
This switches the remote hand set on – green LED flashes for
5 seconds in combination with the acoustic alarm until the
control unit is ready for operation. If LED does not illuminate,
check polarity and condition of batteries in remote hand set.
The remote hand set switches itself off after about 2 minutes
if no buttons are pressed.
Check whether both drive motors are stationary. Press the
"forwards" button with the remote hand set switched on –
both drive motors must now move in the forward direction.
Engage the drive rollers against the tyres by using the remote
hand set.
Please ensure that there are no obstructions beneath the cara-
van, then release the handbrake. Now check all functionality
as per the operating instructions.
Apply caravan handbrake. Disengage the drive rollers and
move slide switch on remote hand set to the "Off"  position
to switch the remote hand set and the Mover® off. Re-check
distance between drive rollers and tyres. Adjust if necessary.
The distance between the disengaged drive rollers and
the tyres is 20 mm.

Warning information

The yellow sticker with the warning information, which is
enclosed with the appliance, must be affixed by the installer
or vehicle owner to a place in the vehicle where it is clearly
visible to all users (e.g. on the wardrobe door)! Ask Truma to
send you a sticker, if necessary.
❙
position.
25