Sharp AR-650 Service Handbook page 97

(5) Remove the following parts of the rear side
(refer to the figure on the right).
*1 pusher
*2 gears
(6) Remove the SHAFT-TRAY.
(screws: 1 at the rear, 1 at the front)
(7) Install the COLLER-SFT-TRAY (2 pieces).
Notes
*When attaching the SHAFT-TRAY, Pay attention to whether it is facing the front or the rear (see below).
Rear
A
*When attaching the gear, be careful to the direction of the gears. (See below; both should face in the
same direction)
ADJUSTMENT
GEAR (BLACK)
: 1 E-ring
COLLER
SHAFT-TRAY
A > B
1 - 90
GEAR (WHITE)
: 1 E-ring
PUSHER
: 2 screws
COLLER
Front
B