Adjusting The Fuser Inlet Guide - Sharp AR-650 Service Handbook

1.21 Adjusting the Fuser Inlet Guide

Check the gap between the inlet guide and the lower heat roller when the following troubles occur:
• Stain on the back side of the paper
• Fuser inlet jam
• Wrinkled paper
(1) Move the screw fixing position to the oblong
hole to make adjustment using the stamped
mark as a guide.
(2) Adjust the gap between the inlet guide and the
< =
lower heat roller. (0.4 gap < 1.7)
1 - 79
Inlet guide
Stamped mark
Inlet guide
Lower heat roller
ADJUSTMENT