CODE
ADJUSMENT
♥340
Scanner copy length reproduction ratio
adjustment.
♥350
RADF single sided original stop position.
♥351
RADF double sided original side 2 stop
position.
356
RADF sensor automatic adjustment and
EEPROM initialization.
Press the START key, WAIT is displayed while
the automatic adjustment is performed.
♥401
Polygonal motor speed fine adjustment.
♥405
Polygonal motor speed fine adjustment.
ADJUSTMENT
05 MODE
MODE
DEFAULT RANGE
Copier
128
0-255
Adjust the length of the copy
image to 1:1 so that it is not
stretched or compressed. Use
a millimeter scale and ledger/
A3 paper to adjust. Increasing
the value decreases the length
0.05% step(or 0.1mm/step).
All
8
0-15
The higher the value, the more
the original is fed towards the
paper feed side of the
machine.
1 step is equal to approxi-
mately 1mm change.
Test copy can be made in 05
test mode.
All
8
0-15
The higher the value, the more
the original is fed towards the
exit side of the machine.
1 step is equal to approxi-
mately 1mm change.
Test copy cannot be made in
05 test mode. Press 09 to
enter normal copy mode and
toggle back to 05 mode to
adjust.
All
—
—
Perform RADF EEPROM
Initialization when EEPROM,
RADF logic PWA or sensors
are replaced.
Printer
128
0-255
Adjust the width of the printed
image (front to rear of
machine) to 1:1, so that it is
not stretched or compressed.
When the value is increased
by 1, the width reproduction
ratio is enlarged by approxi-
mately 0.05% step (or 0.1mm/
step). After setting the value,
select LT/A4 paper, then press
the ENERGY SAVER key to
make a test print.
Copier
120
0-255
Adjust the width of the copied
image (front to rear) to 1:1 so
that it is not stretched or
compressed. When the value
is increased by 1, the width
reproduction ratio is enlarged
by approximately 0.05%/step
(or 0.1mm/step). After setting
the value, select LT/A4 paper,
then press the ENERGY
SAVER key to make a test
copy.
1 - 16
PROCEDURE
DESCRIPTION
GROUP
1
1
1
4
1
1