Output Mapping; Direct 1 To 18; Gy Aileron, Elevator, Rudder - PowerBox Systems Mercury SRS Instruction Manual

This completes the Setup Assistant procedure. In the following stage all
the remaining functions, such as retract system, brakes and lighting, are
assigned and adjusted where necessary using the servo-matching
function.

5. Output mapping

Since the Setup Assistant does not cover all the functions, Output Mapping
is employed to assign additional functions to the outputs; it is also possible
to shift existing functions to other outputs.
As can be seen in the screen-shot above, the left-hand column shows the
output letter; the centre lists the assigned function or the transmitter
channel; and the right-hand column is used to set each output to Hold or
Failsafe if the radio link should fail.
The following set-up facilities are provided for FUNCTION:

- DIRECT 1 to 18:

Depending on your radio control system, channels 1 to 18 can be output
directly, as they arrive from the transmitter.
Example: at your transmitter the wheel brakes are assigned to channel 9,
and you wish to connect the brakes to output E. Move the cursor to E and
confirm your choice by pressing the SET button. Set the following at E:
DIRECT 9. The servo connected to output E now follows commands from
channel 9 at your transmitter 1:1 - unless, that is, you have made
adjustments using the servo-matching facility.

- GY AILERON, ELEVATOR, RUDDER:

If you select one of these functions, the output is linked internally with the
iGyro output. Two outputs are available for each axis: GY AILE-R, GY
AILE-L, GY ELEV-R, GY ELEV-L, GY RUDD-A, GY RUDD-B.
Each of these axes is individually variable for gain, direction of effect and
gyro function.
-14-