Menu; Basic Settings; Selecting The Radio Control System - PowerBox Systems Mercury SRS Instruction Manual

Digital battery display
Flight time since the
last reset
Receiver status

2. Menu

Hold the SET button pressed in for two or three seconds to enter the menu
system; you can now move the cursor using buttons I and II. Hold the SET
button pressed in once you have selected a particular menu point; you can
then adjust values and settings using buttons I and II.

3. Basic settings

3.1. Selecting the radio control system

The Mercury SRS must be informed which radio control system you wish
to use, as the bus systems of the various manufacturers differ very widely.
You only need to enter this information once.
The unit's integral SRS system selects one receiver when switched on,
and automatically switches over to the second receiver if the signal is lost.
Regardless of the type of radio control system employed, the change-over
process takes just a few milliseconds, and is not noticeable to the pilot.
The Mercury SRS can also be operated with a single receiver.
Select the GENERAL SETTINGS point at the main menu, then press the
SET button; the following screen display appears:
Voltage display in bar form showing also low voltage
threshold to display voltage drops
-04-
Output voltage
iGyro flight mode
GPS status