Set Up; General Information; Adjustment Elements - Vega VEGAVIB 63 Operating Instructions Manual

Function/Configuration
Electronics and connec-
tion compartment
Switching point adapta-
tion (1)
VEGAVIB 63 • - contactless electronic switch

6 Set up

6.1 General information

The figures in brackets refer to the following illustrations.
On the electronics module you will find the following indicating and

adjustment elements:

Potentiometer for adaptation to the product density (1)
l
DIL switch for mode adjustment - min./max. (2)
l
Signal lamp (5)
l
Note:
As a rule, always set the mode with mode switch (2) before starting the
setup of VEGAVIB 63. The switching output will change if you set the
mode switch (2) afterwards. This could possibly trigger other
connected instruments or devices.
6.2 Adjustment elements
5
4
Fig. 10: Electronics and connection compartment - contactless electronic switch
Potentiometer for switching point adaptation
1
DIL switch for mode adjustment
2
3 Ground terminal
Connection terminals
4
5 Control lamp
With the potentiometer you can adapt the switching point to the solid. It
is already preset and must only be modified in special cases.
6 Set up
1
2
3
19