Wiring Plan, Single Chamber Housing - Vega VEGAVIB 63 Operating Instructions Manual

5 Connecting to power supply
16
5
Lift the opening levers of the terminals with a screwdriver (see
following illustration)
Fig. 7: Connection steps 5 and 6
6
Insert the wire ends into the open terminals according to the wiring
plan
7
Press down the opening levers of the terminals, you will hear the
terminal spring closing
8
Check the hold of the wires in the terminals by lightly pulling on
them
9
Tighten the compression nut of the cable entry. The seal ring must
completely encircle the cable
10 If necessary, carry out a fresh adjustment
11 Screw the housing cover back on
The electrical connection is finished.

5.3 Wiring plan, single chamber housing

The following illustrations apply to the non-Ex as well as to the EEx-d
version.
VEGAVIB 63 • - contactless electronic switch