Set Up; Indication Of The Switching Status; Function Test - Vega VEGASWING 51 Operating Instructions Manual

6 Set up

18
6 Set up

6.1 Indication of the switching status

The switching status of the electronics can be checked via the signal
lamp integrated in the upper part of the housing.

6.2 Function test

VEGASWING 51 has an integrated test switch which can be activated
magnetically. Proceed as follows to test the instrument:
à Hold the test magnet (accessory) to the magnet symbol on the
instrument housing
Fig. 11: Function test
The test magnet changes the current switching condition of the
instrument. You can check the change on the signal lamp. Please note
that the connected instruments are activated during the test.
If VEGASWING 51 does not switch over after several tests with the
test magnet, you have to check the plug connection and the
connection cable and test the instrument again. If there is no switching
function, the electronics will be defective. In this case you have to
exchange the electronics or return the instrument to our repair
department.
Caution:
It is absolutely necessary that you remove the test magnet after the
test from the instrument housing.
VEGASWING 51 • - contactless electronic switch