Setting The Reference; Editing The Contents Of The Home View - ABB ACS-AP-x User Manual

44 Functions in the Options menu

Setting the reference

You can change the reference when the drive is in the local control mode. You can
also change the reference in remote control mode if the drive configuration permits it.
Changes take effect when saved with a key press.
to switch to the local control mode, if the text in the top left
1. Press
Loc/Rem
corner of the display reads Remote.
2. In the Options menu, select Reference.
3. Change the reference by using the following keys:
• Use or
• Use and
(
4. Press Save
changes. The control panel returns to the Home view.
Tip: To adjust the reference from the Home view, press
or and the reference changes immediately. The
reference value is highlighted when you are changing it. If
you hold down the arrow key, the rate at which the value
changes accelerates.

Editing the contents of the Home view

1. In the Options menu, select Edit Home view. This opens the Home view in the
editing mode.
2. In the editing mode, you can add, edit and delete the displayed parameters.
After editing the contents, press
the editing mode and return to the Home view.
Two-signal page in editing mode
3. In the editing mode, use
Home view.
• To add a new page, navigate to the page that reads Press Add to make a new
screen.
• To edit, add or delete parameters on an existing page, navigate to that page.
to select a digit to edit.
to change the value of the selected digit.
)
to save the reference value, or
Softkey labels
and a blinking
cursor indicate
that the
control panel is
and to move between the different pages of the
(Done) to confirm the changes and to exit
Empty page in editing mode
(Cancel) to discard the
1200.0 rpm
60.0